Garelick 2 Step EEZ-In I/O Swim Platform with Boat Ladder
The platform mounts at a 10 degree angle on the transom and each step is covered with a flat poly tread for easy, comfortable boarding. The platform is pre-drilled for easy assembly and includes two 1"
stainless steel wraparound rails that can be installed on either side of
the transom.
- Ladder Material: Stainless steel
- Platform Material: Molded polypropylene
- Step Material: 304 Stainless steel covered with flat poly tread
- Mounting: Transom
- Stowage: Steps telescope closed and ladder slides under platform
- Mount Attachment: Flush mount on transom See Installation Instructions
Swim Platform Ladder Dimensions
Measure for Fit
Locate the space on your transom where it would be best to mount your swim platform ladder. Measure the top of where you will be mounting the ladder to the top of the waterline and compare it with the length of the ladder to determine how far (or how many steps) the ladder will extend below the waterline.
For the width, measure the available width clearance where you will be mounting the platform ladder on the transom. Be sure to take in account the boat motor or any other accessories you will have on the stern of your boat. This will let you know the maximum width available for mounting your platform ladder.
Important Note
Backing plates or large washers are strongly recommended for all ladder installations. They will help distribute the load over a larger area to avoid potential damage. In some instances failure to use a backing plate may void the manufacturers warranty.